Hydraulic Press Brake

Hydraulic Shearing Machine

'ANASUYA' presents to you a range of most technically advanced hydraulic shearing machines with all latest features as per international standards.

Salient Features

  • The stable robust, all welded steel frame from ultra sonically tested plates are of top quality. Raw & table designed with special inclined member & box type structure for maximum strength.
  • The top beam is guided by three point roller with replaceable hardened liners for least wear. This eliminates lubrication of steel to provide better quality of cutting for a longer time.
  • Rake angle can be varied to permit shearing of higher thickness than nominal capacity & facilitating distortion free shearing of thin sheets.
  • The fastest & easiest way of blade clearance setting without need of feeler gauge, which helps burr-free edges.
  • Positive holding by hydraulic hold downs before shearing avoids slippage of sheets & independent operation of hold downs for clamping of sheet helps checking of mark without taking shear stroke.
  • Front gauging by dis appearing stoppers mounted on left squaring arm. Robust, heavy & accurate back gauging to set cutting width.
  • Hydraulic cylinder are designed with both low & high pressure sealing, hard chrome plated rod also with special type guide for long life without leakage.
  • Hydraulic components are of international quality standards & assembled on specially designed compact manifold block for easy maintenance.

Standard Accessories

  • Main Drive Motor
  • Electric Control Panel
  • Operational Console.
  • Pre selector switch to adjust rake angle
  • Lever operated blade clearance with calibration
  • Front sheet support
  • Hardened transfer bar mounted on table
  • Hold down cylinders
  • Four edge HCHCR / HCSR blade Interchangeable & suitable to shear mild and St. Steel
  • Manual back gauge

Optional Accessories

  • Motorised back gauge with DRO
  • NC back gauge with ball screw
  • Second squaring arm on left side
  • Front support with roller according to required length
  • Rear sheet support
  • Ball transfer table
  • Degree protector for angular cutting
  • Stroke counter
  • Design with throat depth
  • First fill of hydraulic oil